Service manual

Maintenance
B.A.S.I.S. V Service Manual 11–3
Reinstalling the
backup battery
1. Slide the backup battery under the clip and into position in the
battery socket.
2. For standard locks, peel away the protective backing from the edge
of the escutcheon gasket and slide the gasket onto the upper
escutcheon post. Press the gasket into place so the electronics
board is covered.
For exit hardware trim, reinstall the following parts in the
escutcheon:
■ mounting plate (page 10–7)
■ lift finger (page 10–5)
■ escutcheon gasket (page 10–3)
■ mounting standoffs (page 10–2).
3. For standard locks, reinstall the inside and outside escutcheons on
the door. For mortise lock instructions, see page 5–6. For cylindrical
lock instructions, see page 7–8.
For exit hardware trim, reinstall the escutcheon on the door. See
page 8–14.
Figure 11.2 Reinstalling the backup battery (escutcheon for standard mortise lock
shown)
Outside escutcheon
Battery clip
Battery socket
Backup battery
Slide the backup battery
under the clip.