Service manual

Servicing Exit Hardware Trim Escutcheon Parts
B.A.S.I.S. V Service Manual 10–31
2. Make sure that the shear pin is positioned in the lever so that the
head faces the opposite direction of the lever handle. Then insert
the lever through the escutcheon, positioning the lever so its handle
will point toward the door hinges. See Figure 10.17.
3. Reinstall the following parts:
■ beam and beam roller (page 10–25)
■ yoke (page 10–23)
■ lever return springs (page 10–8)
■ mounting plate (page 10–7)
■ lift finger (page 10–5)
■ escutcheon gasket (page 10–3)
■ mounting standoffs (page 10–2)
■ escutcheon on the door (page 8–14).
Figure 10.17 Changing the handing
Shear pin head
Lever