Service manual

Servicing Exit Hardware Trim Escutcheon Parts
10–30 B.A.S.I.S. V Service Manual
CHANGING THE HANDING
Each time you change the handing you need to replace the following
parts with new parts:
■ escutcheon gasket (C64564)
■ cable tie
■ lift finger screw (page 4–9)
■ mounting plate screws (page 4–9)
■ 4 shoulder screws (page 4–10).
Note: When changing the handing for Precision Hardware mortise
applications, you must replace the lift finger with the correct lift finger
for the desired handing. To order the left-hand lift finger, use part
number C64576. To order the right-hand lift finger, use part number
C64568.
1. Remove the following parts:
■ escutcheon from the door (page 8–13)
■ mounting standoffs (page 10–2)
■ escutcheon gasket (page 10–3)
■ lift finger (page 10–4)
■ mounting plate (page 10–6)
■ lever return springs page 10–8)
■ yoke (page 10–22)
■ beam and beam roller (page 10–24)
■ lever assembly (page 10–26).