Service manual

Servicing Exit Hardware Trim Escutcheon Parts
B.A.S.I.S. V Service Manual 10–27
Reinstalling the
lever assembly
1. Make sure that the shear pin is positioned on the lever so that the
head faces the opposite direction of the lever handle. See
Figure 10.16.
2. Insert the lever through the escutcheon, positioning the lever so its
handle will point toward the door hinges. See Figure 10.15.
3. Reinstall the following parts:
■ beam and beam roller (page 10–25)
■ yoke (page 10–23)
■ lever return spring (page 10–8)
■ mounting plate (page 10–7)
■ lift finger (page 10–5)
■ escutcheon gasket (page 10–3)
■ mounting standoffs (page 10–2)
■ escutcheon (page 8–14).