Service manual

Servicing Exit Hardware Trim Escutcheon Parts
B.A.S.I.S. V Service Manual 10–25
3. Remove the beam and beam roller from the lever spindle. See
Figure 10.14.
Reinstalling the
beam and
beam roller
1. Place the beam on the lever spindle so that the slot in the beam
aligns with the locking plate. See Figure 10.14.
2. Reinstall the c-clip onto the lever spindle. The orientation of the clip
does not matter. See Figure 10.13.
3. Place the beam roller on the beam.
4. Reinstall the following parts:
■ yoke (page 10–23)
■ lever return springs (page 10–8)
■ mounting plate (page 10–7)
■ lift finger (page 10–5)
■ escutcheon gasket (page 10–3)
■ mounting standoffs (page 10–2)
■ escutcheon on the door (page 8–14).
Figure 10.14 Removing and reinstalling the beam and beam roller
Beam
Slot in beam
Beam roller
Lever spindle
Locking plate