Service manual

Servicing Exit Hardware Trim Escutcheon Parts
10–24 B.A.S.I.S. V Service Manual
SERVICING THE BEAM AND BEAM ROLLER
Each time you service the beam or beam roller you need to replace the
following parts with new parts:
■ escutcheon gasket (C64564)
■ cable tie
■ lift finger screw (page 4–9)
■ mounting plate screws (page 4–9)
■ 4 shoulder screws (page 4–10).
Removing the beam
and beam roller
1. Remove the following parts:
■ escutcheon from the door (page 8–13)
■ mounting standoffs (page 10–2)
■ escutcheon gasket (page 10–3)
■ lift finger (page 10–4)
■ mounting plate (page 10–6)
■ lever return springs (page 10–8)
■ yoke (page 10–22).
2. Remove the c-clip from the lever spindle. See Figure 10.13.
Figure 10.13 Removing and reinstalling the c-clip
Lever spindle
C-clip