Service manual

Servicing Exit Hardware Trim Escutcheon Parts
B.A.S.I.S. V Service Manual 10–21
Reinstalling the
locking plate
1. Slide the locking plate into position as shown in Figure 10.11. Make
sure that the locking lever of the motor assembly is inserted through
the locking plate.
2. Reinstall the following parts:
■ motor assembly (page 10–17)
■ lever return springs (page 10–8)
■ mounting plate (page 10–7)
■ lift finger (page 10–5)
■ escutcheon gasket (page 10–3)
■ mounting standoffs (page 10–2)
■ escutcheon on the door (page 8–14).
Figure 10.11 Reinstalling the locking plate
Locking plate
Locking lever