Service manual

Servicing Exit Hardware Trim Escutcheon Parts
B.A.S.I.S. V Service Manual 10–17
3. Using a screwdriver, pry the sounder off the escutcheon.
4. Using a 3/32″ hex driver, remove the socket head screw and spacer.
Remove the motor assembly from the escutcheon.
Reinstalling the
motor assembly
1. Rotate the gear on the motor assembly until the locking lever is as
close to the screw hole as possible, as shown in Figure 10.7.
Note: If the locking lever does not move freely as you turn the gear,
gently move the locking lever into position.
2. Position the motor assembly in the escutcheon as shown in
Figure 10.8. Make sure that:
■ the locking lever is inserted through the locking plate.
■ the motor assembly pivot pin is seated in the recess in the
escutcheon
Figure 10.7 Rotating the motor assembly gear
Pivot pin
Gear
Locking lever
Socket head screw hole