Service manual

Servicing Exit Hardware Trim Escutcheon Parts
10–16 B.A.S.I.S. V Service Manual
SERVICING THE MOTOR ASSEMBLY
Replacement kits are available for motor assemblies. See page 4–10.
Each time you service the motor assembly you need to replace the
following parts with new parts:
■ escutcheon gasket (C64564)
■ cable tie
■ lift finger screw (page 4–9)
■ mounting plate screws (page 4–9)
■ tape for mounting the sounder.
Removing the motor
assembly
1. Remove the following components:
■ escutcheon from the door (page 8–13)
■ mounting standoffs (page 10–2)
■ escutcheon gasket (page 10–3)
■ lift finger (page 10–4)
■ mounting plate (page 10–6)
■ lever return springs (page 10–8).
2. Disconnect the motor connector from the primary harness. See
Figure 10.6.
Figure 10.6 Removing the motor assembly
Socket head screw
Sounder
Motor connector
Motor assembly