Service manual

Servicing Exit Hardware Trim Escutcheon Parts
B.A.S.I.S. V Service Manual 10–15
Reinstalling the
dual validation
reader assembly
1. Perform steps 1 and 2 on page 9–27.
2. Reinstall the following parts:
■ electronics board (page 10–12)
■ primary harness (page 10–10)
■ mounting plate (page 10–7)
■ lift finger (page 10–5)
■ escutcheon gasket (page 10–3)
■ mounting standoffs (page 10–2)
■ escutcheon on the door (page 8–14).
Removing the
proximity reader
assembly
1. Remove the following parts:
■ escutcheon from the door (page 8–13)
■ mounting standoffs (page 10–2)
■ escutcheon gasket (page 10–3)
■ lift finger (page 10–4)
■ mounting plate (page 10–6)
■ primary harness (page 10–10)
■ electronics board (page 10–13).
2. Perform steps 2 and 3 on page 9–28.
Reinstalling the
proximity reader
assembly
1. Perform steps 1 and 2 on page 9–29.
2. Reinstall the following parts:
■ electronics board (page 10–13).
■ primary harness (page 10–10)
■ mounting plate (page 10–7)
■ lift finger (page 10–5)
■ escutcheon gasket (page 10–3)
■ mounting standoffs (page 10–2)
■ escutcheon on the door (page 8–14).