Service manual

Servicing Exit Hardware Trim Escutcheon Parts
B.A.S.I.S. V Service Manual 10–13
Removing the
proximity control
electronics board
1. Remove the following parts:
■ escutcheon from the door (page 8–13)
■ mounting standoffs (page 10–2)
■ escutcheon gasket (page 10–3)
■ lift finger (page 10–4)
■ mounting plate (page 10–6)
■ primary harness (page 10–10).
2. Perform steps 2 and 3 starting on page 9–16.
Reinstalling the
proximity control
electronics board
1. Perform steps 1 through 3 on page 9–17.
2. Reinstall the following parts:
■ primary harness (page 10–10)
■ mounting plate (page 10–7)
■ lift finger (page 10–5)
■ escutcheon gasket (page 10–3)
■ mounting standoffs (page 10–2)
■ escutcheon on the door (page 8–14).
SERVICING THE READER ASSEMBLIES
Replacement kits are available for the reader assemblies. See page 4–4.
Each time you service the reader assembly you need to replace the
following parts with new parts:
■ escutcheon gasket (C64564)
■ cable tie
■ lift finger screw (page 4–9)
■ mounting plate screws (page 4–9).
Removing the
magnetic stripe
reader assembly
1. Remove the following parts:
■ escutcheon from the door (page 8–13)
■ mounting standoffs (page 10–2)
■ escutcheon gasket (page 10–3)
■ lift finger (page 10–4)
■ mounting plate (page 10–6)
■ primary harness (page 10–10)
■ electronics board (page 10–10).
2. Perform steps 2 and 3 starting on page 9–19.