Service manual

Servicing Exit Hardware Trim Escutcheon Parts
B.A.S.I.S. V Service Manual 10–11
Reinstalling the
magnetic stripe
control electronics
board
1. Perform steps 1 through 5 on page 9–11.
2. Reinstall the following parts:
■ primary harness (page 10–10)
■ mounting plate (page 10–7)
■ lift finger (page 10–5)
■ escutcheon gasket (page 10–3)
■ mounting standoffs (page 10–2)
■ escutcheon on the door (page 8–14).
Removing the
smart card control
electronics board
1. Remove the following parts:
■ escutcheon from the door (page 8–13)
■ mounting standoffs (page 10–2)
■ escutcheon gasket (page 10–3)
■ lift finger (page 10–4)
■ mounting plate (page 10–6)
■ primary harness (page 10–10).
2. Perform steps 2 through 4 starting on page 9–12.
Reinstalling the
smart card control
electronics board
1. Perform steps 1 through 5 starting on page 9–13.
2. Reinstall the following parts:
■ primary harness (page 10–10)
■ mounting plate (page 10–7)
■ lift finger (page 10–5)
■ escutcheon gasket (page 10–3)
■ mounting standoffs (page 10–2)
■ escutcheon on the door (page 8–14).
Removing the dual
validation control
electronics board
1. Remove the following parts:
■ escutcheon from the door (page 8–13)
■ mounting standoffs (page 10–2)
■ escutcheon gasket (page 10–3)
■ lift finger (page 10–4)
■ mounting plate (page 10–6)
■ primary harness (page 10–10).
2. Perform steps 2 and 3 on page 9–15.