Service manual

Servicing Exit Hardware Trim Escutcheon Parts
10–10 B.A.S.I.S. V Service Manual
Removing the
primary harness
1. Remove the following parts:
■ escutcheon from the door (page 8–13)
■ mounting standoffs (page 10–2)
■ escutcheon gasket (page 10–3)
■ lift finger (page 10–4)
■ mounting plate (page 10–6).
2. Perform steps 2 through 4 starting on page 9–7.
Reinstalling the
primary harness
1. Perform steps 1 through 3 starting on page 9–8.
2. Reinstall the following parts:
■ mounting plate (page 10–7)
■ lift finger (page 10–5)
■ escutcheon gasket (page 10–3)
■ mounting standoffs (page 10–2)
■ escutcheon on the door (page 8–14).
SERVICING THE CONTROL ELECTRONICS BOARDS
Replacement kits are available for control electronics boards.
See page 4–5.
Each time you service the control electronics board you need to replace
the following parts with new parts:
■ escutcheon gasket (C64564)
■ cable tie
■ lift finger screw (page 4–9)
■ mounting plate screws (page 4–9).
Note: To determine whether a lock has a B.A.S.I.S. G or B.A.S.I.S. V
control electronics board, look at the label on the center of the board.
B.A.S.I.S. G is labeled as BAGLKS. B.A.S.I.S. V is labeled as BA_LKS.
Removing the
magnetic stripe
control electronics
board
1. Remove the following parts:
■ escutcheon from the door (page 8–13)
■ mounting standoffs (page 10–2)
■ escutcheon gasket (page 10–3)
■ lift finger (page 10–4)
■ mounting plate (page 10–6)
■ primary harness (page 10–10).
2. Perform steps 2 and 3 on page 9–10.