Service manual

Servicing Exit Hardware Trim Escutcheon Parts

10–8 B.A.S.I.S. V Service Manual

SERVICING THE LEVER RETURN SPRINGS

Each time you service the lever return springs you need to replace the

following parts with new parts:

■ escutcheon gasket (C64564)

■ cable tie

■ lift finger screw (page 4–9)

■ mounting plate screws (page 4–9).

Removing the lever

return springs

1. Remove the following parts:

■ escutcheon from the door (page 8–13)

■ mounting standoffs (page 10–2)

■ escutcheon gasket (page 10–3)

■ lift finger (page 10–4)

■ mounting plate (page 10–6).

2. Remove the lever return springs from the yoke. See Figure 10.5.

Reinstalling the

lever return springs

1. Install the lever return springs onto the yoke posts. See Figure 10.5.

2. Reinstall the following parts:

■ mounting plate (page 10–7)

■ lift finger (page 10–5)

■ escutcheon gasket (page 10–3)

■ mounting standoffs (page 10–2)

■ escutcheon on the door (page 8–14).

Figure 10.5 Removing and reinstalling the lever return springs

Yoke

Lever return spring