Service manual

Servicing Exit Hardware Trim Escutcheon Parts
B.A.S.I.S. V Service Manual 10–7
Caution
Be careful not to drop the lever return springs on the control
electronics board. They can easily damage the electronics.
Reinstalling the
mounting plate
1. With the posts on the mounting plate inserted in the lever return
springs, slide the mounting plate into the escutcheon. See Figure
Figure 10.5.
Make sure that the locking plate fits into the slot in the mounting
plate. See Figure 10.4.
2. Install the 5 new mounting plate screws.
3. Route the primary harness against the mounting plate post and
secure the harness to the post with a cable tie. See Figure 10.4.
4. Reinstall the following parts:
■ lift finger (page 10–5)
■ escutcheon gasket (page 10–3)
■ mounting standoffs (page 10–2)
■ escutcheon on the door (page 8–14).