Service manual

Servicing Exit Hardware Trim Escutcheon Parts
10–2 B.A.S.I.S. V Service Manual
Note: When servicing components, always test that the lock works
properly when you’re finished.
SERVICING THE MOUNTING STANDOFFS
Removing the
mounting standoffs
1. Remove the escutcheon from the door. See page 8–13.
2. Unscrew the 6 mounting plate standoffs from the mounting plate.
Reinstalling the
mounting standoffs
1. Screw the 6 mounting standoffs onto the mounting plate.
2. Reinstall the escutcheon on the door. See page 8–14.
Control electronics board page 10–10
Reader assembly page 10–13
Motor assembly page 10–16
Locking plate page 10–20
Yoke page 10–22
Beam and beam roller page 10–24
Lever assembly page 10–26
Shear pin page 10–28
If you need to service… See…
Figure 10.1 Removing and reinstalling the mounting standoffs
Mounting standoffs
Mounting standoffs
Mounting plate