Service manual

B.A.S.I.S. V Service Manual 10–1
10
SERVICING EXIT HARDWARE
T
RIM ESCUTCHEON PARTS
This chapter contains instructions for servicing
escutcheon parts for B.A.S.I.S. V EX Series Exit
Hardware Trim. For instructions for servicing
standard B.A.S.I.S. outside escutcheon parts, see
page 9–1.
■ To remove all of the parts from the B.A.S.I.S.
escutcheon, perform all of the steps for removing
parts in each section of this chapter. Begin with
the mounting standoffs (page 10–2).
■ To reinstall all of the parts in the B.A.S.I.S.
escutcheon, perform all of the steps for
reinstalling parts in each section of this chapter.
Begin with the shear pin (page 10–29).
■ To change the handing for the B.A.S.I.S.
escutcheon, see page 10–30.
■ To service an individual part, see the section for
that part. The instructions refer to other sections
as necessary.
If you need to service… See…
Mounting standoffs page 10–2
Escutcheon gasket page 10–3
Lift finger page 10–4
Mounting plate page 10–6
Lever return springs page 10–8
Lens covers page 10–9
Primary harness page 10–9