Service manual

Servicing Standard Outside Escutcheon Parts
9–28 B.A.S.I.S. V Service Manual
Reinstalling the
proximity reader
assembly
1. Orient the proximity reader assembly and insert the prongs through
the slots in the outside escutcheon. See Figure 9.25.
2. Position the reader assembly on the reader gasket and install the
four reader assembly mounting screws. See Figure 9.24.
3. Reinstall the following parts:
■ electronics board (page 9–17)
■ primary harness (page 9–8, step 1)
■ sensor harness (page 9–6)
■ upgrade cable (page 9–5)
■ harness clamp (page 9–4)
■ escutcheon gasket (page 9–2)
■ inside and outside escutcheons. For mortise lock instructions, see
page 5–6. For cylindrical lock instructions, see page 7–8.
,
Figure 9.25 Positioning the proximity reader assembly
Proximity reader assembly
Outside escutcheon
Slot
Reader gasket
Location of prongs