Service manual

Servicing Standard Outside Escutcheon Parts
B.A.S.I.S. V Service Manual 9–27
Removing the
proximity reader
assembly
1. Remove the following parts:
■ inside and outside escutcheons. For mortise lock instructions,
see page 5–3. For cylindrical lock instructions, see page 7–5.
■ escutcheon gasket (page 9–2)
■ harness clamp (page 9–4)
■ upgrade cable (page 9–5)
■ sensor harness (page 9–6)
■ primary harness (step 2, page 9–7)
■ electronics board (page 9–16).
2. Remove and save the four reader assembly mounting screws.
See Figure 9.24.
3. Remove the proximity reader assembly from the outside
escutcheon.
Figure 9.24 Removing the proximity reader assembly from the outside escutcheon
Reader assembly mounting screw