Service manual

Servicing Standard Outside Escutcheon Parts
9–26 B.A.S.I.S. V Service Manual
Reinstalling the
dual validation
reader assembly
1. Orient the dual validation reader assembly and insert the reader
cable through the slot in the outside escutcheon. See Figure 9.23.
2. Position the reader assembly on the reader gasket and install the
four reader assembly mounting screws. See Figure 9.21.
3. Reinstall the following parts:
electronics board (page 9–15)
primary harness (page 9–8, step 1)
sensor harness (page 9–6)
upgrade cable (page 9–5)
harness clamp (page 9–4)
escutcheon gasket (page 9–2)
inside and outside escutcheons. For mortise lock instructions, see
page 5–6. For cylindrical lock instructions, see page 7–8.
,
Figure 9.23 Positioning the dual validation reader assembly
Reader cable
Outside escutcheon
Slot
Reader gasket
Dual validation
reader assembly