Service manual

Servicing Standard Outside Escutcheon Parts
B.A.S.I.S. V Service Manual 9–23
Reinstalling the
smart card reader
assembly
1. Orient the reader assembly and insert the flex cable through the slot
in the outside escutcheon. See Figure 9.20.
2. Position the smart card reader assembly on the reader gasket and
install the four reader assembly mounting screws. See Figure 9.18.
3. Reinstall the following parts:
■ electronics board (page 9–13)
■ primary harness (step 1, page 9–8)
■ sensor harness (page 9–6)
■ upgrade cable (page 9–5)
■ harness clamp (page 9–4)
■ escutcheon gasket (page 9–2)
■ inside and outside escutcheons. For mortise lock instructions, see
page 5–6. For cylindrical lock instructions, see page 7–8.
Figure 9.20 Positioning the smart card reader assembly
Slot
Reader gasket
Flex cable
Smart card
reader assembly
Outside escutcheon