Service manual

Servicing Standard Outside Escutcheon Parts
9–18 B.A.S.I.S. V Service Manual
SERVICING THE READER ASSEMBLIES
Replacement kits are available for the reader assemblies. See page 4–4.
Removing the
magnetic stripe
reader assembly
1. Remove the following parts:
■ inside and outside escutcheons. For mortise lock instructions,
see page 5–3. For cylindrical lock instructions, see page 7–5.
■ escutcheon gasket (page 9–2)
■ harness clamp (page 9–4)
■ upgrade cable (page 9–5)
■ sensor harness (page 9–6)
■ primary harness (step 2, page 9–7)
■ electronics board (page 9–12).
2. Remove and save the four reader assembly mounting screws.
See Figure 9.15.
Figure 9.15 Removing and reinstalling the screws for the magnetic stripe reader
assembly
Reader assembly
mounting screw