Service manual

Servicing Standard Outside Escutcheon Parts
B.A.S.I.S. V Service Manual 9–17
3. Carefully pull the electronics board straight out from the
escutcheon and remove it. Set aside the electronics board.
Reinstalling the
proximity control
electronics board
1. If you are installing a new control electronics board, pull down on
the backup battery tab and remove it from the outside escutcheon
to turn on the backup battery.
Caution
For the lock to operate properly, you must remove the backup battery
tab.
Caution
Do not connect the battery pack before you have removed the backup
battery tab. Doing so may cause the lock to malfunction.
2. Align the connectors on the back of the electronics board with the
reader pins. Press the board into place.
3. Install the two electronics board mounting screws, but do not
tighten the screw for the harness clamp.
Note: The jumper shown in Figure 9.14 must be installed in order to
use an ABA card format with a proximity card reader. This jumper
must be removed to use a Weigand card format.
4. Reinstall the following parts:
■ primary harness (page 9–8, step 1)
■ sensor harness (page 9–6)
■ upgrade cable (page 9–5)
■ harness clamp (and tighten the electronics board mounting
screw) (page 9–4)
■ escutcheon gasket (page 9–2)
■ inside and outside escutcheons. For mortise lock instructions, see
page 5–6. For cylindrical lock instructions, see page 7–8.
Figure 9.14 Removing and reinstalling the proximity control electronics board
Electronics board
Outside escutcheon
Electronics board
mounting screw
(used for harness
clamp)
Electronics board
mounting screw
Retaining ring
Jumper