Service manual

Servicing Standard Outside Escutcheon Parts
9–16 B.A.S.I.S. V Service Manual
2. Firmly connect the reader harness to the connector on the
upper-left corner of the electronics board. The connector should
snap into place. See Figure 9.13.
3. Route the reader cable so it fits in between the top of the
electronics board and the escutcheon.
4. Position the electronics board in the escutcheon so the LEDs fit into
the retaining rings.
5. Install the two electronics board mounting screws, but do not
tighten the screw for the harness clamp.
6. Reinstall the following parts:
■ primary harness (page 9–8, step 1)
■ sensor harness (page 9–6)
■ upgrade cable (page 9–5)
■ harness clamp (and tighten the electronics board mounting
screw) (page 9–4)
■ escutcheon gasket (page 9–2)
■ inside and outside escutcheons. For mortise lock instructions, see
page 5–6. For cylindrical lock instructions, see page 7–8.
Removing the
proximity control
electronics board
1. Remove the following parts:
■ inside and outside escutcheons. For mortise lock instructions,
see page 5–3. For cylindrical lock instructions, see page 7–5.
■ escutcheon gasket (page 9–2)
■ harness clamp (page 9–4)
■ upgrade cable (page 9–5)
■ sensor harness (page 9–6)
■ primary harness (page 9–7, step 2).
2. Remove and save the electronics board mounting screws.
See Figure 9.14.