Service manual

Servicing Standard Outside Escutcheon Parts
9–14 B.A.S.I.S. V Service Manual
4. Flip down the electronics board and position it in the escutcheon so
the LEDs fit into the retaining rings.
5. Install the two electronics board mounting screws, but do not
tighten the screw for the harness clamp.
6. Reinstall the following parts:
■ primary harness (page 9–8, step 1)
■ sensor harness (page 9–6)
■ upgrade cable (page 9–5)
■ harness clamp (and tighten the electronics board mounting
screw) (page 9–4)
■ escutcheon gasket (page 9–2)
■ inside and outside escutcheons. For mortise lock instructions, see
page 5–6. For cylindrical lock instructions, see page 7–8.
.
Figure 9.12 Connecting the flex cable to the smart card control electronics board
Black part of the connector
Retaining ring