Service manual

Servicing Standard Outside Escutcheon Parts
B.A.S.I.S. V Service Manual 9–13
4. Slide open the flex cable connector and disconnect the flex cable.
Set aside the electronics board. See Figure 9.11.
Reinstalling the
smart card control
electronics board
1. If you are installing a new control electronics board, pull down on
the backup battery tab and remove it from the outside escutcheon
to turn on the backup battery.
Caution
For the lock to operate properly, you must remove the backup battery
tab.
Caution
Do not connect the battery pack before you have removed the backup
battery tab. Doing so may cause the lock to malfunction.
2. Insert the flex cable into the connector on the back of the
electronics board. See Figure 9.12.
3. Slide closed the flex cable connector.
Figure 9.11 Disconnecting the flex cable from the smart card control electronics
board
Flex cable connector
Flex cable
Back of electronics board