Service manual

Servicing Standard Outside Escutcheon Parts
9–12 B.A.S.I.S. V Service Manual
Removing the
smart card control
electronics board
1. Remove the following parts:
■ inside and outside escutcheons. For mortise lock instructions,
see page 5–3. For cylindrical lock instructions, see page 7–5.
■ escutcheon gasket (page 9–2)
■ harness clamp (page 9–4)
■ upgrade cable (page 9–5)
■ sensor harness (page 9–6)
■ primary harness (step 2, page 9–7).
2. Remove and save the electronics board mounting screws.
See Figure 9.10.
3. Flip up the control electronics board.
Figure 9.10 Removing and reinstalling the smart card control electronics board
Retaining ring Retaining ring
Electronics board
Outside escutcheon
Electronics board
mounting screw
Electronics board
mounting screw
(used for harness
clamp)