Service manual
Servicing Standard Outside Escutcheon Parts
9–10 B.A.S.I.S. V Service Manual
SERVICING THE CONTROL ELECTRONICS BOARDS
Replacement kits are available for control electronics boards.
See page 4–5.
Note: To determine whether a lock has a B.A.S.I.S. G or B.A.S.I.S. V
control electronics board, look at the label on the center of the board.
B.A.S.I.S. G is labeled as BAGLKS. B.A.S.I.S. V is labeled as BA_LKS.
Removing the
magnetic stripe
control electronics
board
1. Remove the following parts:
■ inside and outside escutcheons. For mortise lock instructions,
see page 5–3. For cylindrical lock instructions, see page 7–5.
■ escutcheon gasket (page 9–2)
■ harness clamp (page 9–4)
■ upgrade cable (page 9–5)
■ sensor harness (page 9–6)
■ primary harness (page 9–7, step 2).
2. Remove and save the electronics board mounting screws.
See Figure 9.9.
3. Disconnect the reader harness from the electronics board. Set aside
the electronics board.
Figure 9.9 Removing and reinstalling the magnetic stripe
control electronics board
Electronics board
mounting screw
Reader harness
Electronics board
Outside escutcheon
Retaining ringGreen LED
Electronics board
mounting screw
(used for harness
clamp)