Service manual

Servicing Standard Outside Escutcheon Parts
B.A.S.I.S. V Service Manual 9–7
SERVICING THE PRIMARY HARNESS
A replacement kit is available for the primary harness. See page 4–6.
Removing the
primary harness
1. Remove the following parts:
■ inside and outside escutcheons. For mortise lock instructions,
see page 5–3. For cylindrical lock instructions, see page 7–5.
■ escutcheon gasket (page 9–2)
■ harness clamp (page 9–4).
2. Disconnect the primary harness from the electronics board.
3. Insert a flat blade screwdriver under the sounder and turn it to
remove the sounder from the outside escutcheon.
Figure 9.6 Removing and reinstalling the primary harness from the
electronics board (smart card reader shown)
Primary harness connector
(J3)
Outside escutcheon