Service manual

Servicing Standard Outside Escutcheon Parts
B.A.S.I.S. V Service Manual 9–5
SERVICING THE UPGRADE CABLE
A replacement kit is available for the upgrade cable. See page 4–6.
Note: The upgrade cable is for future use.
Removing the
upgrade cable
1. Remove the following parts:
■ inside and outside escutcheons. For mortise lock instructions,
see page 5–3. For cylindrical lock instructions, see page 7–5.
■ escutcheon gasket (page 9–2)
■ harness clamp (page 9–4).
2. Disconnect the upgrade cable from the electronics board.
Reinstalling the
upgrade cable
1. Connect the upgrade cable to the J1 connector on the electronics
board.
2. Reinstall the following parts:
■ harness clamp (page 9–4)
■ escutcheon gasket (page 9–2)
■ inside and outside escutcheons. For mortise lock instructions, see
page 5–6. For cylindrical lock instructions, see page 7–8.
Figure 9.4 Removing and reinstalling the upgrade cable
(smart card reader shown)
Upgrade cable connector
Outside escutcheon