Service manual

Servicing Standard Outside Escutcheon Parts
9–4 B.A.S.I.S. V Service Manual
SERVICING THE HARNESS CLAMP
Removing the
harness clamp
1. Remove the following parts:
■ inside and outside escutcheons. For mortise lock instructions,
see page 5–3. For cylindrical lock instructions, see page 7–5.
■ escutcheon gasket (page 9–2).
2. Loosen the electronics board mounting screw that holds the harness
clamp and remove the clamp.
Reinstalling the
harness clamp
1. Slide the harness clamp under the loosened electronics board
mounting screw.
2. Position the primary harness, sensor harness (EV, FV, and LV
function mortise locks), and upgrade cable under the clamp, as
shown in Figure 9.3.
Note: For a description of lock functions, see page 2–2.
3. Tighten the screw.
4. Reinstall the following parts:
■ escutcheon gasket (page 9–2)
■ inside and outside escutcheons. For mortise lock instructions, see
page 5–6. For cylindrical lock instructions, see page 7–8.
Figure 9.3 Removing and reinstalling the harness clamp
(smart card reader shown)
Electronics board
mounting screw
Harness clamp
Primary harness
Outside escutcheon
Upgrade cable
(J1)
Sensor harness