Service manual

Servicing Standard Outside Escutcheon Parts
9–2 B.A.S.I.S. V Service Manual
SERVICING THE ESCUTCHEON GASKET
Caution
Before you handle the control electronics board or any component
on the control electronics board, make sure that you are properly
grounded using an electrostatic discharge (ESD) protection kit.
Touching the control electronics board without proper grounding can
damage sensitive electronic components—even if you don’t notice
any static discharge.
Removing the
escutcheon gasket
1. Remove the inside and outside escutcheons from the door. For
mortise lock instructions, see page 5–3. For cylindrical lock
instructions, see page 7–5.
2. Remove the escutcheon gasket from the escutcheon and discard the
gasket.
Reinstalling the
escutcheon gasket
1. Peel away the protective backing from the edge of the escutcheon
gasket and slide the gasket onto the upper escutcheon post. Press
the gasket into place on the edge of the escutcheon so the
electronics board is covered.
2. Reinstall the inside and outside escutcheons on the door. For
mortise lock instructions, see page 5–6. For cylindrical lock
instructions, see page 7–8.
Figure 9.1 Removing and reinstalling the escutcheon gasket
Gasket
Outside escutcheon
Upper post