Service manual

B.A.S.I.S. V Service Manual 9–1
9
SERVICING STANDARD
O
UTSIDE ESCUTCHEON PARTS
This chapter contains instructions for servicing
outside escutcheon parts for a standard B.A.S.I.S. V
Lock. For instructions on servicing EX Series Exit
Hardware Trim parts, see page 10–1.
■ To remove all of the parts from the outside
escutcheon, perform all of the steps for removing
parts in each section of this chapter. Begin with
the escutcheon gasket (page 9–2).
■ To reinstall all of the parts in the outside
escutcheon, perform all of the steps for
reinstalling parts in each section of this chapter.
Begin with the reader assembly (page 9–18).
■ To service an individual part, see the section for
that part. The instructions refer to other sections
as necessary.
Note: When servicing components, always test that
the lock works properly when you’re finished.
If you need to service… See…
Escutcheon gasket page 9–2
Lens covers page 9–3
Harness clamp page 9–4
Upgrade cable page 9–5
Sensor harness or conversion harness page 9–6
Primary harness page 9–7
Control electronics board page 9–10
Reader assembly page 9–18