Service manual

Servicing Exit Hardware Trim Parts
8–14 B.A.S.I.S. V Service Manual
Reinstalling the
escutcheon
1. If installing an escutcheon for a Von Duprin EV function rim or
rod exit device, reinstall the cylinder in the escutcheon. See
page 8–12.
2. If installing a new B.A.S.I.S. escutcheon, activate the backup
battery:
a. Locate the backup battery tab on the inside of the B.A.S.I.S.
escutcheon.
b. Pull down on the tab and remove it from the B.A.S.I.S.
escutcheon to turn on the backup battery.
Caution
For the lock to operate properly, you must remove the backup battery
tab.
Caution
Do not connect the battery pack before you have removed the backup
battery tab. Doing so may cause the lock to malfunction.
3. From the outside of the door, feed the com port and battery
connector through the harness hole as shown in Figure 8.10.
Caution
When routing the connectors, make sure the harnesses are not routed
across any sharp edges or over any surface that could damage their
sleeving or wire insulation.
4. Rest the B.A.S.I.S. escutcheon on the door by inserting the trim
studs into the mounting holes.
5. Reinstall the following parts:
cylinder (for EV function locks) (page 8–11 for a Precision
Hardware rim or rod exit device installation, or page 8–10 for a
mortise exit device installation)
core (for EV function locks) (page 8–9)
exit hardware (page 8–8)
battery bracket (page 8–7)
battery pack (page 8–5)
battery cover (page 8–3).