Service manual

Servicing Exit Hardware Trim Parts
B.A.S.I.S. V Service Manual 8–13
SERVICING THE B.A.S.I.S. ESCUTCHEON
Removing the
escutcheon
1. Remove the following parts:
■ battery cover (page 8–3)
■ battery pack (page 8–4)
■ battery bracket (page 8–6)
■ exit hardware (page 8–8)
■ core (for EV function locks) (page 8–9)
■ cylinder (for EV function locks) (page 8–11 for a Precision
Hardware rim or rod exit device installation, or page 8–10 for a
mortise exit device installation).
Note: If removing the escutcheon for a Von Duprin EV function rim
or rod exit device installation, you cannot remove the cylinder from
the escutcheon until you have removed the escutcheon from the
door. See page 8–12.
2. Remove the escutcheon from the door, feeding the battery
connector and com port out the harness hole.
Figure 8.10 Removing and reinstalling the escutcheon
Com port
B.A.S.I.S. escutcheon
Outside of door
Battery connector
Harness hole