Service manual

Figures
xiv B.A.S.I.S. V Service Manual
Removing the smart card reader assembly from the outside escutcheon 9–23
Positioning the smart card reader assembly 9–24
Removing and reinstalling the screws for the dual validation reader assembly
9–25
Removing the dual validation reader assembly from the outside escutcheon
9–26
Positioning the dual validation reader assembly 9–27
Removing the proximity reader assembly from the outside escutcheon 9–28
Positioning the proximity reader assembly 9–29
SERVICING EXIT HARDWARE TRIM ESCUTCHEON PARTS
Removing and reinstalling the mounting standoffs 10–2
Removing and reinstalling the escutcheon gasket 10–3
Removing and reinstalling the lift finger (Precision Hardware rim configuration
shown) 10–4
Removing and reinstalling the mounting plate 10–6
Removing and reinstalling the lever return springs 10–8
Removing the motor assembly 10–16
Rotating the motor assembly gear 10–17
Routing the motor harness 10–18
Reinstalling the motor assembly 10–19
Removing and reinstalling the locking plate 10–20
Reinstalling the locking plate 10–21
Removing and reinstalling the yoke 10–22
Removing and reinstalling the c-clip 10–24
Removing and reinstalling the beam and beam roller 10–25
Removing and reinstalling the lever assembly 10–26
Removing and reinstalling the shear pin 10–28
Changing the handing 10–31
MAINTENANCE
Removing the backup battery (escutcheon for standard mortise lock shown)
11–2
Reinstalling the backup battery (escutcheon for standard mortise lock shown)
11–3
Removing the battery door (four-cell door shown) 11–4
Removing the battery pack (four-cell pack shown) 11–5
Reinstalling the battery pack (eight-cell pack shown) 11–6
Reinstalling the battery door (eight-cell door shown) 11–7
Removing and reinstalling the battery cover on the battery bracket 11–8
Removing and reinstalling the battery pack 11–8