Service manual

Servicing Exit Hardware Trim Parts
B.A.S.I.S. V Service Manual 8–7
Reinstalling the
battery bracket
1. Routing the wire harness into the bottom of the battery bracket,
slide the com port into its mounting slot inside the battery bracket
as shown in Figure 8.4.
Note: The com port is used when programming the control
electronics for the lock.
2. Tighten the nut to secure the com port to the bracket.
3. Position the battery bracket on the inside of the door as shown in
Figure 8.3.
Note: If reinstalling with a surface rod exit device, the battery
bracket is mounted over the upper rod.
4. Secure the battery bracket to the door using the two mounting
screws.
Note: Doors less than 2″ in thickness use 1 1/4″ screws. Doors 2″ or
greater use 1 3/4″ screws.
Caution
When routing the wire harness, make sure the wires are not routed
across any sharp edges or over any surface that could damage their
sleeving or wire insulation.
5. Reinstall the following parts:
■ battery pack (page 8–5)
■ battery cover (page 8–3).