Service manual

Servicing Exit Hardware Trim Parts
B.A.S.I.S. V Service Manual 8–5
Reinstalling the
battery pack
Note: Replacement battery packs are shipped with foam attached, but
foam is not needed for EX Series Exit Hardware Trim. Remove and
discard the foam before installing the battery pack.
1. Connect the battery pack to the battery connector on the wire
harness shown in Figure 8.2.
Note: The battery connector has 3 wires and 3 pins. The wire colors
are:
■ red with white stripe
■ white
■ black with white stripe.
Caution
When connecting the battery pack, make sure there are no loose wire
connections where the wires are inserted into the connectors and the
connectors are firmly mated.
2. Place the battery pack in the holder inside the battery bracket and
dress the wire harness inside the bracket.
Caution
Make sure you do not damage the sleeving on the battery pack.
Doing so may cause the batteries to be drained.
3. If reinstalling with a surface rod device, dress the wire harness
inside the bracket to the left of the rod so that the harness will not
interfere with the movement of the rods.
We recommend that you loosely coil the harness and use a cable tie
to secure the coil. To avoid damaging the harness, do not put any
sharp bends in it or flex it close to the connectors.
Caution
Failure to dress the wire harness away from the rod could damage
the wire harness, causing the lock’s electronics to not work properly.
4. Reinstall the battery cover. See page 8–3.