Service manual

Servicing Cylindrical Parts

7–16 B.A.S.I.S. V Service Manual

Reinstalling the

rose liners

1. Retract the rose locking pin, and rotate the outside rose liner

clockwise until the proper door thickness groove on the

through-bolt stud lines up with the hub face.

2. Release the rose locking pin. It should lock into the rose liner.

Note: Make sure that the locking pin fully locks into the rose liner.

3. From the outside of the door, insert the lock chassis into the 2 1/8″

chassis hole, routing the motor wire through the notch.

Caution

Make sure that the latch tube prongs engage the chassis frame and

that the latch tailpiece engages the retractor.

4. Place the inside rose liner on the chassis, aligning the holes in the

rose liner with the holes prepared in the door.

Caution

Make sure that there is clearance for the motor wire between the rose

liner and the door.

5. Install the through-bolts through the rose liner and door in the top

and bottom holes.

Figure 7.20 Reinstalling the outside rose liner

2″

2 1/4″

Through-bolt stud

Hub face

Outside rose liner

Rose locking pin

This illustration

shows the chassis

adjusted for a 2

1/4″ thick door.