Service manual

Figures
B.A.S.I.S. V Service Manual xiii
Removing the inside rose liner 7–15
Removing the outside rose liner 7–15
Reinstalling the outside rose liner 7–16
Reinstalling the inside rose liner 7–17
SERVICING EXIT HARDWARE TRIM PARTS
Removing and reinstalling the battery cover on the battery bracket 8–2
Removing and reinstalling the battery pack 8–4
Removing and reinstalling the battery bracket on the door 8–6
Removing and reinstalling the com port in the battery bracket 8–6
Removing and reinstalling the core 8–9
Mortise cylinder components 8–10
Rim cylinder components 8–11
Removing and reinstalling the rim cylinder for Precision Hardware installations
8–11
Removing and reinstalling the rim cylinder for Von Duprin installations 8–12
Removing and reinstalling the escutcheon 8–13
SERVICING STANDARD OUTSIDE ESCUTCHEON PARTS
Removing and reinstalling the escutcheon gasket 9–2
Removing and reinstalling the lens covers (smart card reader shown) 9–3
Removing and reinstalling the harness clamp (smart card reader shown) 9–4
Removing and reinstalling the upgrade cable (smart card reader shown) 9–5
Removing and reinstalling the sensor harness (smart card reader shown) 9–6
Removing and reinstalling the primary harness from the electronics board (smart
card reader shown) 9–7
Disconnecting the sounder and com port from the outside escutcheon 9–8
Connecting the sounder and com port to the outside escutcheon 9–9
Removing and reinstalling the magnetic stripe control electronics board 9–10
Removing and reinstalling the smart card control electronics board 9–12
Disconnecting the flex cable from the smart card control electronics board
9–13
Connecting the flex cable to the smart card control electronics board 9–14
Removing and reinstalling the dual validation control electronics board 9–15
Removing and reinstalling the proximity control electronics board 9–17
Removing and reinstalling the screws for the magnetic stripe reader assembly
9–19
Removing the magnetic stripe reader assembly from the outside escutcheon
9–20
Positioning the magnetic stripe reader assembly 9–21
Removing and reinstalling the screws for the smart card reader assembly 9–22