Service manual

Servicing Cylindrical Parts
B.A.S.I.S. V Service Manual 7–15
SERVICING THE ROSE LINERS
Removing the rose
liners
1. Remove the following parts:
■ core and throw member (page 7–2)
■ levers (page 7–3)
■ escutcheons (page 7–5).
2. Remove the through-bolts from the top and bottom holes in the rose
liner.
3. Slide the inside rose liner off of the door.
4. Slide the chassis assembly out of the door.
5. Retract the rose locking pin, and rotate the outside rose liner until it
is free from the hub.
6. Remove the rose and liner assembly from the sleeve.
E
Figure 7.18 Removing the inside rose liner
Through-bolt
Motor wire
Inside of door
Rose liner
Figure 7.19 Removing the outside rose liner
Hub
Outside rose liner
Rose locking pin
Sleeve