Service manual

Servicing Cylindrical Parts
7–10 B.A.S.I.S. V Service Manual
3. Feed the wire harness connectors through the harness hole:
a. From the outside of the door, feed the upgrade cable connector
through the harness hole.
b. From the outside of the door, feed the motor connector and
battery connector through the harness hole.
Caution
When routing the connectors, make sure the wire harness is not
routed across any sharp edges or over any surface that could damage
its sleeving or wire insulation.
c. Temporarily rest the outside escutcheon on the door by
inserting the trim studs into the trim holes.
Note: You can temporarily install the outside lever to hold the
outside escutcheon in place. See Reinstalling the levers
(page 7–4).
Figure 7.13 Feeding the wire harness connectors through the harness hole
Motor connector
Outside escutcheon
Battery connector
Outside of door
Harness hole
Upgrade connector