Service manual

Servicing Cylindrical Parts
B.A.S.I.S. V Service Manual 7–7
b. Remove the inside escutcheon from the door.
c. From the inside of the door, disconnect the motor connector on
the chassis from its mating connector on the wire harness.
d. Remove the bushings, trim hole inserts, and hub washers from
each side of the door.
Note: Trim hole inserts and hub washers are used only for locks
with brass escutcheons.
Figure 7.9 Disconnecting the motor connector
Inside of door
Motor connector
Figure 7.10 Removing the bushings, trim hole inserts, and hub washers
Trim hole inserts
Bushings
Hub washers