Service manual

Figures
xii B.A.S.I.S. V Service Manual
Locating the backup battery tab 5–6
Reinstalling the trim hole inserts and bushings 5–7
Feeding the wire harness connectors through the harness hole 5–8
Making the motor connection and sensor connections 5–9
Securing the escutcheons 5–10
Reinstalling the battery pack (four-cell pack shown) 5–11
Reinstalling the battery door (four-cell door shown) 5–12
Removing and reinstalling the mounting plates 5–13
Removing and reinstalling the core 5–14
Removing and reinstalling the mortise case faceplate 5–15
Removing and reinstalling the cylinder 5–16
SERVICING STANDARD MORTISE CASE PARTS
Removing and reinstalling the mortise case 6–2
Explanation of the hand and bevel of the door 6–3
Motor module and locking bar in place 6–7
Turning over the auxiliary bolt 6–8
Latchbolt with anti-friction latch lever in position 6–9
Removing and reinstalling the motor module 6–14
Positioning the turn knob hub and deadbolt spring 6–18
Removing and reinstalling the cylinder clamp plate 6–19
SERVICING CYLINDRICAL PARTS
Removing the core and throw member 7–2
Reinstalling the core and throw member 7–2
Removing the keyed lever 7–3
Removing the plain lever 7–3
Reinstalling the levers 7–4
Removing the battery door (four-cell door shown) 7–5
Removing the battery pack (four-cell pack shown) 7–6
Removing the escutcheon 7–6
Disconnecting the motor connector 7–7
Removing the bushings, trim hole inserts, and hub washers 7–7
Locating the backup battery tab 7–8
Reinstalling the bushings, trim hole inserts, and hub washers 7–9
Feeding the wire harness connectors through the harness hole 7–10
Connecting the motor connector 7–11
Securing the escutcheons 7–12
Reinstalling the battery pack (four-cell pack shown) 7–13
Reinstalling the battery door (four-cell door shown) 7–14