Service manual

Servicing Cylindrical Parts
B.A.S.I.S. V Service Manual 7–3
SERVICING THE LEVERS
Removing the levers Removing the keyed lever
1. Remove the core and throw member (page 7–2).
2. Insert a flat blade screwdriver into the figure-8 core hole and into
the lever/knob keeper.
3. Press the screwdriver blade in the direction of the arrow shown in
Figure 7.3.
Note: You will not be able to remove the lever if the screwdriver
blade is inserted too far past the keeper.
4. Slide the lever off of the sleeve.
Removing the plain lever
Insert the protrusion on the spanner wrench into the hole on the shaft
of the lever, as shown in Figure 7.4. Slide the lever off of the sleeve.
Figure 7.3 Removing the keyed lever
Figure-8 core hole
Insert screwdriver blade here.
Lever keeper
Figure 7.4 Removing the plain lever
Protrusion on the spanner wrench
Lever shaft