Service manual

Servicing Standard Mortise Case Parts
B.A.S.I.S. V Service Manual 6–19
Servicing the
cylinder clamp plate
Removing the cylinder clamp plate
1. Remove and open the mortise case (page 6–2).
2. Remove the cylinder clamp plate from the case.
Reinstalling the cylinder clamp plate
1. Insert the cylinder clamp plate into the case so the screw is on the
same side of the case as the concealed cylinder.
2. Close and reinstall the mortise case (page 6–2).
Figure 6.13 Removing and reinstalling the cylinder clamp plate
Cylinder clamp plate