Service manual

Servicing Standard Mortise Case Parts
6–16 B.A.S.I.S. V Service Manual
Servicing the sensor
module
Replacement kits are available for the sensor module. See page 4–10.
Removing the sensor module
1. Remove and open the mortise case (page 6–2).
2. Remove the latch lever.
3. Remove the sensor module.
Reinstalling the sensor module
1. Position the sensor module in the case and route the cables as
shown in Figure 6.10.
2. Reinstall the latch lever.
3. Close and reinstall the mortise case (page 6–2).
Figure 6.10 Removing and reinstalling the sensor module (FV function, LH case shown)
Sensor module
Latch lever
Sensor module
cables