Service manual

Servicing Standard Mortise Case Parts
B.A.S.I.S. V Service Manual 6–13
3. Remove the following parts in the mortise case:
■ sensor module (page 6–16)
■ deadbolt (page 6–18)
■ turn knob hub assembly (page 6–18).
4. For FV to EV conversions, install the new sensor module in the
mortise case.
5. For LV to NV conversions, remove the sensor harness from the
outside escutcheon (page 9–6).
6. Close and reinstall the mortise case (page 6–2).
7. Reinstall all of the trim parts onto the door, including the new inside
escutcheon and faceplate, by performing all of the steps for
reinstalling parts in each section of Chapter 5. Begin with the
cylinder (page 5–16).