Service manual

Servicing Standard Mortise Case Parts
6–12 B.A.S.I.S. V Service Manual
Adding a deadbolt To add a deadbolt, you can convert an EV function lock to an
FV function lock or an NV function lock to an LV function lock.
Note: For a description of lock functions, see page 2–2.
Order these parts/kits and perform the tasks below:
inside escutcheon, part number
faceplate, part number D34095
sensor harness kit, part number 1833728 (NV to LV)
sensor module kit, part number 1833885 (EV to FV)
1838747 (NV to LV)
deadbolt, part number B35035
turn knob hub assembly (includes hub and spacer), part
number A35000.
1. Remove all of the trim parts from the door, by performing all of the
steps for removing parts in each section of Chapter 5. Begin with
the levers (page 5–2).
2. Remove and open the mortise case (page 6–2).
3. Install the following parts in the mortise case:
sensor module (page 6–16)
deadbolt (page 6–18)
turn knob hub assembly (page 6–18).
4. For NV to LV conversions, install the sensor harness kit in the
outside escutcheon.
5. Close and reinstall the mortise case (page 6–2).
6. Reinstall all of the trim parts onto the door, including the new inside
escutcheon and faceplate, by performing all of the steps for
reinstalling parts in each section of Chapter 5. Begin with the
cylinder (page 5–16).
Removing a
deadbolt
To remove a deadbolt, you can convert an FV function lock to a
EV function lock or an LV function lock to an NV function lock.
Note: For a description of lock functions, see page 2–2.
Order these parts/kits and perform the tasks below:
inside escutcheon, part number B60778
sensor module, part number B60794 (FV to EV)
faceplate, part number B34515.
1. Remove all of the trim parts from the door, by performing all of the
steps for removing parts in each section of Chapter 5. Begin with
the levers (page 5–2).
2. Remove and open the mortise case (page 6–2).