Service manual

Service and Maintenance for Cylindrical Locks
5–10 W Series Service Manual
Task B. To adjust for the door’s thickness:
1. Determine the door’s thickness.
2. Pull the rose locking pin and rotate the outside rose liner until the
proper groove on the through-bolt stud lines up with the hub face.
Note 1: Make sure that the locking pin fully locks into the rose liner.
Note 2: The lock fits doors 1 3/4″ to 2 1/4″ thick.
(A spacer is available for 1 3/8″ doors.)
Figure 5.11 Adjusting the outside liner for the door thickness
1 3/4″
2″
2 1/4″ groove
Through-bolt stud
Hub face
Outside rose liner
Rose locking pin